http://www.technicalnet.ch/iphone/Frontcamera.JPG
http://i395.photobucket.com/albums/p...HMJ/5la2c0.gif
Printable View
friends,Quote:
Originally Posted by jammy
If this parts is gone Or not work.
Completely remove this parts and make jumper try again
update here
so what.... Some time it will damage...... If you camera not work remove it carefully and make the jumper.............................Quote:
Originally Posted by raul8ahdz
And post your result....................................
no its not same................................Quote:
Originally Posted by 413kal
friendsQuote:
Originally Posted by bozinsky
yes use electrical flexible (multy point cable) use 1 point or use jumper cable found in market
I need help , please!
I've replace my front camera for iphone 4 still does not work.
you tried make this jumper??????Quote:
Originally Posted by weewee
you have iphone 4??? try the jumper and post you result.....................................Quote:
Originally Posted by qmgs
its very simple no need video dissemble your device and see the mother board try with pic on shown ...............Quote:
Originally Posted by skatekid09
http://www.youtube.com/watch?v=5Joy63ms2QIQuote:
Originally Posted by terribletim
Oh and pls tell more about the problem of Back Camera Too how to check it ..?
sir it's only a simple jumper..Quote:
Originally Posted by skatekid09
tried ang tested by me that's kind of jumper of camera..!
Is it safe to Assume jumping this fixes the front camera...
Attachment 31093
and somehow jumping this repairs the rear camera?
Attachment 31094
Ok so after opening the device and inspecting the logic board both sets of points seem to be intact. I then checked for continuity in the jump points from the first picture above, and then the points from the second picture with a multimeter. The first set seem fine however the second set gave a high impedance (~100Ohm) in both directions. Should I remove the connector at the second point set and jump it with a solder bridge?
