I have updated my HWK Box by using some third party software that make my HWK dead.
Solution:
Firstly, I Updated Its drivers "USB <-> Serial" by using "D2XX Drivers 2.08.30 WHQL Certified.exe" from FTDI website.
secondly, I run "MProg v3.0" and Click File>New then in Device Type Select FT232BM, USB VID/PID select Own VID & PID and in Vendor ID: 0888 Product ID: 5508 then in Manufacturar type UFS3 and Product Description type UFS3 SarasSoft and Un-select Only Program Blank Devices and finaly select Use Fixed Serial Number and type here your box serial number of 6 digit and go to File>Save and now go to Device>Scan and then Device>Program.
Remove your device and reconnect again and provide proper location for your new device drivers in UFS folder and you have done...
Third and finally, Use Box 20Repair and click Connect and wait for 30 seconds, then click Update Firmware and wait till it completed and then click Exit.
Now it is done you can use your Update client for this device..