I9003 Boot Repair Done




Hardware Connection :

Solder TRST, TDI, TMS, TCK, TDO, SRST, GND Lines from Box port to phone PCB carefully.

Insert phone battery and press Power On key after pressing "Connect Device" or "Run Easy Repair" software button, while progress bar is active.

Hold phone Power On key during initial connection.

In most cases insert Samsung GT-I9003 SD Boot Card in to phone's SD slot before resurection (SD Boot Card Image and Disk Image Tool can be downloaded from support)

If everything soldered ok , phone is ready for JTAG operations.
. Flashing Phone Firmware after boot repair :

Press VOL DOWN + HOME + POWER for flash mode

Use capable flasher software for firmware restore.