3100 ringer problem

[jagan]

i change ringer ic there no sound any jumper image

[shah87n]

Here I M Upload Ringer Ways

May Be Help U

[danish jalal]

shah u r right .............. but ............ if not working rehot upp becarefully

















danish_jalal@yahoo.com

[celldoct]

many 3100 has this fault.... jus check if d board is bent... in time span this happens due to the not tighten screws... or heat.... so try to level it by adujustment... i tried this ..it worked ...n bro the direct jumper by our membe bro vl not work snice it by pass the driver... jus check this way ... (try to change the inner ringer also)
n for info if it is upp problem jus chek batt termi for readings if it is less than 250 (beep way n other side is 1..)in digi meter it is upp problem..
BR
post reply

[sekharv]

brother for this problem there is solution 100 % working ok.give a jumper to if ic 1st pin to that block resistor.lot of sets done

[odri]

sir sekharv can you post jumper picture?hope you will help.

[mobiteck]

Shah Is Right Try It Is Help Ful Pic

[rashid]

i change ringer ic there no sound any jumper image

dear check post result

[dilip_patel]

brother for this problem there is solution 100 % working ok.give a jumper to if ic 1st pin to that block resistor.lot of sets done

bro plzzzzzzzzzz block resistor locketion upp ic to black resistor jumper solution

[richard_wifi]

[QUOTE=danish jalal;36916]shah u r right .............. but ............ if not working rehot upp becarefully




bro..i agree with danish..reheat/reball upp then post result