Help : Winmax W200 Hang On logo and then white after flash
Winmax W200 Hang On logo and then white after flash
Info.....
Quote:
>>> Getting Mobile Connection Info...
VCC Pin:
GND Pin:
Signal Pin:2, 3, 4, 8,
>>> Scanning Mobile PinOut...
>>> USB Pinfind No need Hold Mobile Power key...
USB Pin Out: D+:3 D-:2
HardWare:VID:17_82 PID:4D_00
This is a Spreadtrun chip set...
>>> Scanning Mobile USB Port...
>>> Detecting COM PortCOM5
Driver Name->>>SCI USB2Serial
>>> Connecting Mobile...
Mobile Connection Success...
Mobile Firmware Version:SPRD3
>>> Downloading First Boot...
>>> Mobile Info
Project ID :Spreadtrum Boot Block version 1.2
Format info..
Quote:
>>> Getting Mobile Connection Info...
VCC Pin:
GND Pin:
Signal Pin:2, 3, 4, 8,
>>> Scanning Mobile PinOut...
>>> USB Pinfind No need Hold Mobile Power key...
USB Pin Out: D+:3 D-:2
HardWare:VID:17_82 PID:4D_00
This is a Spreadtrun chip set...
>>> Scanning Mobile USB Port...
>>> Detecting COM PortCOM5
Driver Name->>>SCI USB2Serial
>>> Connecting Mobile...
Mobile Connection Success...
Mobile Firmware Version:SPRD3
>>> Downloading First Boot...
>>> Mobile Info
Project ID :Spreadtrum Boot Block version 1.2
Baud Rate is Switched To:921600
>>> Auto Formatting ...
Format Success..
I have flashed with this file....
Quote:
Info : -
CPU_Name = SpreadTrum
CPU_Type = 6531A
Chip_Capacity = 0x040000 (4MB)
Password : Ashfaq Tawhid (Rayan)
Problem same ... What can I do..?