DCT3 Softwares and Windows XP

[neilthirumuttam]

There are only some Dct3 sw tools fully compatible to xp
some may not
But They works perfect in Win 98 And all dct 3 sw problems
can b perfectly solved . examle knok 95 geoflasher etc

how to overcome this compatibilty problem?
it may be very use full if one can run
dejans eeprom repairer(nk_calk) and old rolis tools under xp
can the softwere USERPORT used for this case?
anybody ,
will u pls explain the usage this?

[Bull Mastiff™]

just install the USERPORT so that all dct3 software you have will work on your windows xp..


at your service

[krishna]

Thanks to both of you please tell me about the USERPORT where can i get it

[chennairam]

There are only some Dct3 sw tools fully compatible to xp
some may not
But They works perfect in Win 98 And all dct 3 sw problems
can b perfectly solved . examle knok 95 geoflasher etc

how to overcome this compatibilty problem?
it may be very use full if one can run
dejans eeprom repairer(nk_calk) and old rolis tools under xp
can the softwere USERPORT used for this case?
anybody ,
will u pls explain the usage this?

first download userport with dll
if have her userport with instructions
eeprom also can use without user port
userport use only rolis geoflasher

[neilthirumuttam]

ok thanks for ur responses

let me know some more
how to make nk_calk( EEPROM repair for Nokia DCT3 phones v1.0
) run under xp?

these tools done by dejan , the ultimate dct3 solution his flaher can
full flash read and write possible and calc can repairing
damaged EEPROM data in Nokia DCT3 phones.

Still I belirve no any other solution / algorithm works BETTER than this

(http://users.net.yu/~dejan/)
here it is

[mobiman]

user port gor XP.Run the given file

[neilthirumuttam]

this cant run a16 bit ms dos programme in xp
say some other method

[neilthirumuttam]

is there any resemblence with old nk_calc and ltest bb5 unlocker?
anybody noticed this ?
[both r great gifts from the master brain dejan]

we have to adhere this man in future also
may god bless this man for his service to us

[nayan86]

Thank u all guyz!! for ur nice sharing and coment

[neilthirumuttam]

Sir,


im stil using windows 98 for running dejans nk_calk for repairing some 3310
2100 etc for repairing eep after full flashing

it was ok but recently i changed a mother bord
the new bord having only 1 com port
but nk calk aways seeks com 2
if we install or run setup.bat to configure to com 1
and again run the programme strucks(no response)

but under safe mode nk calc runs normally
and we can assaign to com 1

is ther any method to solve this