1650 led problem'' (ANSWERED)

[manu198655]

Hi guys,
By mistake i hve remove the both led n prints also so display light is not coming so plss temme the solution ....????


m repeating that i hv miss the print either so plss help me...???

[TarikuL]

Hi guys,
By mistake i hve remove the both led n prints also so display light is not coming so plss temme the solution ....????


m repeating that i hv miss the print either so plss help me...???

HERE ALL SOLUTION ABOUT 1650
SEE THIS POST

http://www.gsmindia.in/forum/nokia-h...tml#post142728

OR
http://www.4shared.com/file/6-PbM27G...L_SOLUTON.html

[manu198655]

Bt as i told that i hv miss the prints of led so gimme any other solution....

[TarikuL]

Bt as i told that i hv miss the prints of led so gimme any other solution....

HERE 1650 schematic Diagram
Try or wait if can anyone give you more good solution

[One_Hermit]

Bt as i told that i hv miss the prints of led so gimme any other solution....

Try This Way :

Attachment 26541

Attachment 26542

Post Result...

[jayantassam]

Bt as i told that i hv miss the prints of led so gimme any other solution....

plz send image of damage area i will try....

[jayantassam]

Bt as i told that i hv miss the prints of led so gimme any other solution....

if you miss only led track then try the image

[manu198655]

@ skynet'' Sir i hv missed led prints too so plzz gimme any other solution ....

[manu198655]

Jst find da image.....

[jayantassam]

Jst find da image.....

did u try the jumper

[manu198655]

Sir ji'' led prints nt available.. dats why i cnt try ths''

[jayantassam]

Sir ji'' led prints nt available.. dats why i cnt try ths''

make jumper as in image at out side (not in pcb).....if ok then fix with glue ..post result

[manu198655]

Sir, i still dint understnd outside mean where.. So cn u show me where i cn fix it...???

[jayantassam]

Sir, i still dint understnd outside mean where.. So cn u show me where i cn fix it...???

outside mean

try with jumper wire....you need only three piece of wire..

try the image

[manu198655]

Bt sir in 2nd jumpher u told to fix on led prints bt both prints r missd frm there....