2626 flash problem

MXKEY [MxKey Team HTI Flasher Interface (WinUSB) 3], SN: C086ADAD
Using device: HTI, FW ver: 00.50, SN: 00012A31
Connection status: UHCI:HUB:USB 2.00 (Full-speed)
Driver: WinUSB, ver: 3.5.0.0
Module ver: 1.0.0.19663(13-12-2011), Library ver: 1.0.0.13672(13-12-2011)
ASIC ID: 0x3040 [UPP_4M ver: 4.1]
SecondaryBoot: u3_2nd.fia [DCT4] version: 4.76.0 revision: 0.7 size: 0x9A8
Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
FlashID0: 0001 2C7E [AMD S29NS128N,128 Mbits] page size: 128 K type: NOR area: 01000000-01FFFFFF
FlashID1: 0000 0001 [unused/removed]
ExtBUSC: AD7E B61A 1BBE 0BE2 7D58 6BE4 DBEE 6514
Algorithm: u3_amd.fia [DCT4 ALGORITHM] version: 4.76.0 revision: 0.7 size: 0x78C0
Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
Performing Flash Authentication ...OK
UEM ID: 0018EF1B:DA3BDA66
ASIC type: 11
UEM Imei: Empty
Flash Imei: 3593350228xxxx
MasterCode: 0674333723
RPL saved to "C:\mobileEx\3.5\data\backup\_BACK.rpl"

You set UEM Damage.
Soldering or replace

First Try to Write RPL...

If Not Work Do as Tarikul Says...