RIFF JTAG - CDMA HTC Droid Eris, HTC Polaris and more

RIFF JTAG - CDMA HTC Droid Eris, HTC Polaris and more

12.04.2011 CDMA HTC Droid Eris, Unbrick, Boot Repair, ModelID repair supported

Resurrecting HTC Droid Eris is easy. Phone is auto powered on with USB Data Cable connected to the PC. Battery presence is not required; connection can be established with detached board.
Additionally to SPL and Radio zones, the zone which contains Model ID is re-flashed too. Thus after resurrection phone will have Model ID = ‘PB0010000′.
To resurrect HTC Droid Eris:

• Solder JTAG cable to HTC Droid Eris JTAG pads;
• Insert USB Data cable into board and PC;
• Make sure HTC Droid Eris is selected in the list of models;
• If you use battery, press Power On key;
• Click Resurrect button;
• Wait till software signals a successful operation completion;
• Disconnect power supply, de-solder JTAG wires;

Now phone is in bootable condition, that is, even if it does not start up normally, you can flash it using known flashing methods.


To enter download mode:

• Disconnect PC cable;
• Insert battery;
• Hold ‘Volume down’ key and press ‘Power ON’ button to enter HBoot menu;
• Hold ‘Volume up’ key and press ‘Power ON’ button to enter Recovery mode;

12.04.2011 HTC Polaris (HTC Cruise) Unbrick, Unlock, IMEI and CID Update, ModelID repair supported

Resurrecting HTC Polaris is easy.
Resurrector will reflash radio’s boot zone and will re-write PDA’s SPL to 2.20.AxeBox. Additionally, the zone which contains Model ID is re-flashed too. Thus after resurrection phone will have Model ID = ‘POLA10000′.

To resurrect HTC Polaris:

• Solder JTAG cable to HTC Polaris JTAG pads;
• Insert USB Data cable into board and PC;
• Make sure HTC Polaris selected in the list of models;
• If you use battery, press Power On key;
• Click Resurrect button;
• Wait till software signals a successful operation completion;
• Disconnect power supply, de-solder JTAG wires;

Now phone is in bootable condition, that is, even if it does not start up normally, you can flash it using known flashing method

Whats new:

Added support for NOR Chips which have Intel/Sharp Extended Command Set (according to the CFI specification)

This means any NOR flash chip which is manufactured by CFI standard (it means all NOR flash chips) will be supported with above listed DLL-s. There is no need to update DCC Loaders for single flash chip ID, since configuration data are obtained from CFI.

Check Here