New Solution Repair JAF BOX and without resisters 330 and without remove chip LVC244A

[amaak2008]

Step 1: You have to find a stem LPT port cable as shown:



Just like on the Jack LPT port to attach to the back of the computer.

And on what it has stated that Jack LPT number from 1 to 25 feet (see wealth in'll see). And we only care about 4 feet.

No. 6 feet ..........( called SCK)
No. 7 foot ..............( called Mosi)
No. 9 feet ..............( called reset)
foot No. 10 ............( called miso)

As shown below:



Step 2: Open Box JAF and welding as Figure 1 below.



Step 3: View behind JAF BOX. using a scalpel and cut as shown in Figure 3 below.



Step 4: Connect the USB for the JAF Box to use GND and 5V Voltage

Step 5: Download: soft + Firmware of JAF box
DOWNLOAD
Step 6: Install PonyProg_V207c

Step 7: After installation is complete, we set up as shown below.



The steps to load and select the file you just need to conform to the video is 100% OK. The most important problem is the connection with JAF BOX LPT port only.
See Video
Thanks mr zopo

Don't 4get 2 Hit Thanks Button If You Like My Post...

[engies]

hi, my jaf box cant detect flaser interface solution plssssssssssssssssssssss

[karlux]

I will try repair like you said and i will post the feedback here. i need to updafte from 1b1 to 1b4 beacause infinity dongle works better with this jaf firmware

[karlux]

No images in this post...

[Arvind123]

Where is Step 2 and Step 3 Figure ?

[starmobi]

New Solution Repair box JAF without resisters 330 and without remove chip LVC244A
Step 1: You have to find a stem LPT port cable as shown:

avr_isp_programmer1.jpg


Just like on the Jack LPT port to attach to the back of the computer.

And on what it has stated that Jack LPT number from 1 to 25 feet (see wealth in'll see). And we only care about 4 feet.

No. 6 feet ..........( called SCK)
No. 7 foot ..............( called Mosi)
No. 9 feet ..............( called reset)
foot No. 10 ............( called miso)

As shown below:

LPT.jpg


Step 2: Open Box JAF and welding as Figure 1 below.

JAFfixbyzopo13.jpg

Step 3: View behind JAF BOX. using a scalpel and cut as shown in Figure 3 below.

JAFfixbyzopo34.jpg
Step 4: Connect the USB for the JAF Box to use GND and 5V Voltage

Step 5: Download: soft + Firmware of JAF box

Click here to download


Step 6: Install PonyProg_V207c




Step 7: After installation is complete, we set up as shown below.

JAFfixbyzopo45.jpg

The steps to load and select the file you just need to conform to the video is 100% OK. The most important problem is the connection with JAF BOX LPT port only.





or
download video
RapidShare: 1-CLICK Web hosting - Easy Filehosting

[starmobi]

No images in this post...

Where is Step 2 and Step 3 Figure ?

friends check post #6....