J.A.F is gone,SFI flasher is ready
to use tis software yu hav to update yur jaf box firmware to 01.b4 r b5.
to update jaf firmware install sfi setup and go to program files/SFI/NOK/JAFDRVx64>>>>SFIJAFFWUpd<<<DOUBLE CLICK AND UPDATE YUR BOX FIRMWARE. if it is showin error remove usb and insert again nd try it vil update.
this is beta version til dec 31 yu can use tis vit free register key .to get d key open the software and go to suport there vil be hrdwrd id copy tat and paste in the fillup fourm below gven.get d free reg key
download vit utorrent
Last edited by jamesjerss; 12-24-2010 at 07:13 PM.
Post Thanks / Like - 1 Thanks, 1 Likes
Today I repair my jaf box using SFI software.
First programm it using ponyprog and then update firmware with SFI updater.
Now, my box is OK.
SFI Flasher ready,
1. Official page and support forum
The official forum can be found here:
In this forum you can find the latest updates on this location:
Hidden Content !
After you download the latest update, dowble click on it, and instal it.
In C:\Program Files\ , a new directory will be created ( SFI\NOK ) where you have all needed to run this sw.
If you are using JAF Box for Fbus flashing, the drivers you can find in:
In same directory, you will have updater for your JAF Box: SFIJAFFWUpd.exe
double click on it and follow on screen instructions in order to update your box.
2. Starting software
After you instal the setup, an icon will apear on your desktop :
double click on and, and your sw will start in few seconds.
For the beginning, you will get this message:
It means that you dont have YET licence to use it.
The software will start anyway:
Check DEAD USB box, press Connect and go to Support TAB:
Now go to
and fill the form, including your nickname, your valid email adress, and the HW ID that you saw on that Support tab.
You will receive an email with an valid key for your sw.
After you receive the licence, copy and paste it into the KEY window from right side.
Press UPDATE LICENCE button and press YES if you wish to continue.
Now your sw is ready to use.
SFI SUPPORT Team
Cannot paste license information : Please Help
Dear Team, I am unable to paste licence information into Keydata: window of SFI flasher. Kindly help, it is urgent.
bro uninstall nd try not k den register vit another id nd get d key..
SFI Key data
Open SFI software, Connect it in dead usb mode.
Now you find option to enter key data
Or You can contact me in sfisupport forum in hindi section
Post yopur problem in registration section.
Thankyou very much Master...