nokia 6060 voter dameg

[dilip_patel]

nokia 6060 voter dameg set is dead i trai is hit but not solution jaf is errar Getting MCU ID
Phone didn't answer with TX line high after UEM reset!
Causes:
1. BSI line is not connected properly in connector -> Check cable, also for 3.3k resistor in serial with bsi line.
2.UEM damaged -> replace UEM.

MCU ID: 0xCCCC
Failed! Aborting!
Done!
Phone Restarted...

[celldoct]

hello patel bro,
jus clean the board and chek for short if yes leave it aside if not chek all vio and v flash and flash it hope it works