Micromax cdma c 111 cpu-6010 blinking repair done by riff box

MICROMAX CDMA C 111 CPU-6010 BLINKING REPAIR DONE BY RIFF BOX



Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.34, JTAG Manager Version: 1.43
Selected Resurrector: [Micromax C111 (QSC6010) V1.00]

Connecting to the dead body...OK
Detected dead body ID: 0x200B10E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 4 MHz]
Settings Code: 0x2401000C000000000000000000800000

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x257E (8MB)

Looking for the RIFF BOX DCCLoader USB Interface Port...FAILED
The DCCLoader USB Interface is not found. Communication continues over the DCC Interface

Writting FLASH1 memory from 0x000000000000 to 0x0000007FFFFF
Completed in 00:02:33.953 (Average Transfer Rate: 53.21 kB/s)

================================================== =========

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.34, JTAG Manager Version: 1.43
Selected Resurrector: [Micromax C111 (QSC6010) V1.00]

Connecting to the dead body...OK
Detected dead body ID: 0x200B10E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x257E (8MB)
Flashing the dead body...OK
Resurrection complete!




TESTED FILE ONLY FOR CPU= 6010


http://www.4shared.com/rar/PaddAlTc/...OR_ER_BT_.html



SEE HERE
http://img201.imageshack.us/img201/1015/48722564.png