many mobiles i flash flashing ok after that ui factory Defaults failed.
what r the reasons for this error
what should be done to avoid this error
plzzz plzzzz moderators & members,plzzz give solution :confused::confused:
thanks in advance
Printable View
many mobiles i flash flashing ok after that ui factory Defaults failed.
what r the reasons for this error
what should be done to avoid this error
plzzz plzzzz moderators & members,plzzz give solution :confused::confused:
thanks in advance
someone plzz reply urgent . i am waiting
first click on Check......wait
get info ......wait until mode change and shows info on scr
select UI options
press on UI settings Tab
If problem remain
1) Install sarasoft again
2) Check USB cable
Post reply
still ui defaults failed. what to do???
than problem is in Box.
contact your reseller.
maybe pin inside cable socket of box r broken.:o
i tried in my friends box also but same problem
i have same problm .i think this is fault of flash ic.
i have same problm .i think this is fault of flash ic.
if it is A DCT4,,, FLASH IC(COMBO FLASH)..Quote:
Originally Posted by mobileman
if it is a WD2,,, SDRAM..
RE-FLOW OR REPLACE....
UR cABLE IS NOT FINE CHEQUE UR cABLE AND USE MODIFY CABLE AND THEN CHEQUE UR MOBILE
If my cable is not good how does flashing happen . it shud show error in begening only
can there be some hardware problem in mobile if ui default gets failed ????
Thanks But.......Quote:
Originally Posted by local mode
What about BB5 ??
for bb5 u have to use higher version only........