Can Anybody Help Me To Guide Through . I Want To Know How To Read And Right Uem On Phone I Have Ufs-4 Flasher
Can Anybody Help Me To Guide Through . I Want To Know How To Read And Right Uem On Phone I Have Ufs-4 Flasher
i too need the help of writing RPL file how
i too need the help of writing RPL file
i too need the help....,
after i change the UEM IC what should i want to do,how to write the RPL file.., I HAVE ufs-3 & J.A.FBOX
ADVANCE IN THANKS
Hi Bro
After change the UEM u 1st have to write the RPL File
Ok Follows these Steps...
1- Connect the Phone Wit UFS Via Respected DCT4 Cable (i.e 6610i ufs cable)
2- Select the Respected Model i.e RM-37 (6610i)
3- Click On Wr UEM Button On right side of UFS & wait for the Combo box asking for the "DO You Wana Write Rpl File "
4- Click On Yes Button
5- Then Select the RPL File present in C:\ProgrameFile\Nokia\Phoenix\Imei_Files
6- Select The Respected ASIC (i.e ASIC 2,5,7) etc ASic
7- U can confirm ur Phone Asic . When U click On Yes Button To Confirm Write UEM Ufs Will Show ASIC TYPE Along Wit ??????????????????? , ASIC: 2
8- After This u ahve to Select Any Rpl File acoording to Asic TYpe found in IMEI_FILE Folder..
9- Selelct Any RPl No.
10- After this Wait .... untill ufs Give a message " Click On Ok Button Make Sure Ur Set is SWitch On"
11- Make Sure ur Set is in Local Mode if Not the switch on ur Set Muanlly by pressing on buttin
12- after this wirtting UEM done & intializing Simlock ok
13- Click on info button it will show IMEI:; its mean ur UEM good one & Imei is succeefully Writed ..
14- After Full Flash The SET then ur set is ready to use
Follows These Steps 100% TEsted
Thanks a lot buddy for this wonderful help
Can u help me about reading uem,or from where i will get rpl file
Hi Bro ..
Rpl files r actually within the Ufs Cd's
or when u install the ufs Setup then these files automatically installed in following folder locted at..
C:\Program Files\Nokia\Phoenix\Imei_files\
if Not found i will upload here
ClicK here to Download RPLS ...Attachment 6615
Thanks buddy you are really a helping hand
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks