ABOUT RESET PROCEDURE
RED BLINKING

Sorry… if repost.!
this thread was just my experience as a nubie, about steps “reset procedure”.
Reset procedure used to solve the problem about:
- totally dead (using power supply, power on, amp indicator rise, release power on button indicator back to zero)
- red blink
- identify model (from gdfs) became k700 ect.
- gdfs problem.
- not hardware problem - short ect

the_laser steps:
1. go to emptyboard tab
2. select proper model
3. on settings, check "signed mode"
4. press recovery
5. after succeful recovery
6. on settings uncheck all
7. if gdfs totally damaged, add to firmware area proper gdfs in ssw format,otherwise skip that step
8. add to firmware area proper EROM (EROM CID >= OTP CID)
9. press flash
10. if needed,reflash phone on usual semc tab with needed settings.