hello sir recently I have bought a uct box. it came with gpg cables. among them there is a cable without any connector. it have 24 pinouts but I don't know which pinouts should be used for rx and tx. plz help
Printable View
hello sir recently I have bought a uct box. it came with gpg cables. among them there is a cable without any connector. it have 24 pinouts but I don't know which pinouts should be used for rx and tx. plz help
bro U can Use
Red As RX
Orange As TX
Black As Gnd
but bro this cable has not any wires it has only 24 prints
Make Cable Like This :Quote:
Originally Posted by Mubarak Alam
http://forum.gsmhosting.com/vbb/atta...4&d=1304574186
Use as Universal Rx Tx Cable...
I want to know whichg prints should be connected to the rx, tx, and ground of a mobile from this cable
PLZ HELP I AM CONFUSED ABOUT THIS.
Use Any From Pin 1 to 24 as Rx, Tx & GNDQuote:
Originally Posted by Mubarak Alam
Software will Automatically Detects Them...
Check This :
Attachment 27361
ok, thanks a lot. keep up helping
brother i have gpg open cables.when i attach open cables on mobiles pinouts and grnd positive and negative but set on not showing local mode.i try many times on different mobiles but problem is same plz help me i can do
bro, connect like this may be your problem solvedQuote:
Originally Posted by arslanqadir1
Attachment 28787Attachment 28787Attachment 28787