Hi,

these are the all Philips pinouts.

http://www.biosol.ro/philips/pinout.gif

other hints.

- The jack cable try to make it by yourselves from old Philips 530 external camera, or 755 television convertor cable. Other new models might include this special cable also and you can take the connector. This original conector works BEST, no need to adjust how much you have to plug it, is fixed, no problems on connections or flashings, etc.

- On old Philips Fisio phones flashing might require to play with the voltages between 3V and 6V until you have booted the phone, then remember this setting. This applies for Fisio 12x, 62x, 82x series.

- For old Ozeo phones the required voltage is 3V, no more !! So use the special cable with external power plugs and power it only at 3V, doing otherwise can damage your phone, and also no comunication with the phone.

- If you can't estabilish a comunication with the phone (especially old models) verify if your cable have the resistor on TX pin, most of the universal interface don't have this pull-up by default and you might needed for some phones. (Better is to modify directly inside the universal interface if you have the skills, this pull-up is needed by all the phones)

- If you are using "Jack Flash" (the internal boot), wich is the default flashing for most of the new phones, try to use the normal speed, some flash types are little slow and disrupt the boot communication with the software, resulting dead phone and need to open them and restore them by test points.