2626 dead

[jagan]

Getting MCU ID
Phone didn't answer with TX line high after UEM reset!
Causes:
1. BSI line is not connected properly in connector -> Check cable, also for 3.3k resistor in serial with bsi line.
2.UEM damaged -> replace UEM.

MCU ID: 0xCCCC
Failed! Aborting!
Done!
Phone Restarted...
it is jaf problem or cable problem

[Tema]

You can scratch lightly the contact points of the phone with the cable or remove the board and give a mild heat because the ic that connect the phone with the flashing cable might ve problem.

[richard_wifi]

bro....reball or change UEM....if not ok
change UPP