1200: Dead
Phy condition: water damage
Action taken:
1)clean pcb by elma with ultrasonic bath
2)heat given by 100w bulb upto 1hour
3)during flashing following error comes
Getting MCU ID
Phone didn't answer with TX line high after power on!
Causes:
1. Phone don't power on -> Check cable
2. TX pin from phone don't make contact -> Check cable
3. UPP damaged -> change UPP
MCU ID: 0xAAAA
Failed! Aborting!
Done!
Phone Restarted...
(Note; flashing cable is ok because same cable flash another 1200)
4)reflow upp & uem
any solution?
abhishekh
Bookmarks