Post Any Nokia Set's Hardware Problems Here

[mukesh pathak]

sir i have 1209 with network problem, it shows no network excess.

[One_Hermit]

sir i have 1209 with network problem, it shows no network excess.

Try This :
1. Erase Flash
2. Re-Flash
3. Write Tested PM

If Not Solve Check/Change Antina and PA...

Post Result...

[mukesh pathak]

sir, what is the process of check pa and antina switch.

[mukesh pathak]

nokai 1110 short, when insert battery, display became white and vibrate problem,pls. help me.

[shaiksha85]

nokai 1110 short, when insert battery, display became white and vibrate problem,pls. help me.

Clean It With PCB Cleaner


Check Battery Connector & Charging Connector

If Needed Change It

Check The Section Which Was Getting Heat & Wash it

[One_Hermit]

nokai 1110 short, when insert battery, display became white and vibrate problem,pls. help me.

Remove R220 and Check...

[jayantassam]

nokai 1110 short, when insert battery, display became white and vibrate problem,pls. help me.

nokai 1110 short

try this ..post result

[ravinder yadav]

sir i have 1209 with network problem, it shows no network excess.

try this okkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkkk

[Rajesh Basti]

Sir 5130c was power on it was shows nokia with in two seconds it was blank display after 5 second it was power off i was completed in software but no use what i was do the next step tell me sir pls.....

chainj tha hwelma ic neeyr batri connecter or con.mi mo. no ************

[alikhanak]

2630 speaker ways and lcd light problem . .. plz give me some suggestions..

[One_Hermit]

2630 speaker ways and lcd light problem . .. plz give me some suggestions..

Change Speaker and Check..

For Light Try This :
Attachment 26643

[pretam]

sir my nokia 2700c is on nokia stand by mode without light on display flashing is ok

[shaiksha85]

sir my nokia 2700c is on nokia stand by mode without light on display flashing is ok

U Mean Its Just Getting Internally On With Vibration


Its Hardware (UEM IC ) Complaint

Clean PCB & Rehot Uem

[mukesh pathak]

nokia c1-00 rm-689 dead, any solution please.

[manojkumarpati]

U Mean Its Just Getting Internally On With Vibration


Its Hardware (UEM IC ) Complaint

Clean PCB & Rehot Uem

while installing mx key 3.4 ver 2.1 this message appears %1 is not a valid win 32 application what is the proble and how it will be solve?