share ko lang po baka maka tulong

unit v360 bootloader lang



tools smartclip \ dongle \smart adaptor \ v3 usb cables



unang hakbang ko po d kasi ito ma flashing na hnd muna dadaan sa preapare phones kaya preapare phones muna ako tapos done na repair pds namn ako tapos flashing na ito po



ito po log


Smart Adaptor: serial ......18, firmware version 1.05
Clip serial: .......4, version: 5.03, initializing... OK
Searching for phone... found S Flash Neptune LTE2, getting test interface... interface not found
Switching to flash mode... OK
Searching for phone... found S Flash Neptune LTE2, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 8.A0
Sending boot... OK
Erasing flash memory OK
Sending firmware OK
Searching for phone... found S Blank Neptune LTE2
Switching to flash mode... OK
Reading phone boot version... 3.00
clip communication failed
Smart Adaptor: serial ....8, firmware version 1.05
Clip serial: ....4, version: 5.03, initializing... OK
Searching for phone... found S Flash Neptune LTE2, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 8.A0
Sending boot... OK
Erasing flash memory OK
Sending firmware OK
Searching for phone... found S Blank Neptune LTE2
Switching to flash mode... OK
Reading phone boot version... 3.00
Reading flash id... ST - M30L0R8000B0
Reading flash id/2... none, OK
Phone group: V235,V360,V360v,V3i,V3r,L7,L7e,L7v,L71,L72,L9,K1,U 3,W5,W490,W510,Z3
Hardware IMEI: 356491006368907
IMEI OTP status: locked
Security area saved to "PDS for S Blank Neptune LTE2 356491006368907 (4).mbk"
Now you can perform Repair PDS or Unlock operations.
To get phone to work, you should write flash into the phone
Writing flash section 2 of 2... 100% (83.6 Kb/sec)
Flash completed!

done succes pare hnd ganun kadali ilang bisis kona po ito reflash may error kasi