Tutorial on how to solve Galaxy S3 stuck at Boot issues:
If you do not have Samsung’s KIES installed, download and install it. Correct USB drivers must be installed, so that programs can communicate with the device. Reboot computer after KIES installation.
Odin 3.04: Download Link
http://www.mediafire.com/?e699jwhg50bcw9a
CF-Root-SGS3-v6.0.zip:
Download Link.
http://download.chainfire.eu/185/CF-...-SGS3-v6.0.zip
( After download, please unzip this file. and you will get (CF-Root-SGS3-v6.0.tar)
Step 1: Turn your phones into download mode by pressing and holding VolumeDown + Home + Power simultaneously.
Step 2: Start ODIN on PC.
Step 3: Connect the device to your computer using USB.
Step 4: Wait a few seconds, the ODIN screen will show that a device is now connected. If ODIN not detect your device, mean you still not install the s3 driver/ Samsung kies properly or still not enable the Download Mode.
Step 6: Click the PDA button, then select CF-Root-SGS3-v6.0.tar (Note: this is .tar file and not is .zip file!)
Step 7: Press Odin “Start” button. ODIN will start flash the firmware.
Step 8: The device should reboot into CWM Recovery after flash complete.
Now continue to step below:
2. Wipe data, cache partition and Dalvik Cache.
Step 1: Now your Galaxy s3 boot into CWM Recovery .
Step 2: Select wipe data/factory reset and then choose yes. (Press volume button for selection and power button to enter)
Step 3: Select wipe cache partition and the choose yes. (Press volume button for selection and power button to enter)
Step 4: Go to advanced and do Wipe Dalvik Cache and the choose yes. (Press volume button for selection and power button to enter).
Step 6: Now you need power off your S3, so unplug the battery and then plug in again the battery.
Last step
Atlast Flash Official Galaxy s3 ROM via Odin
Bookmarks