All Nokia Phones Convert

[puneet1484]

3220b to 3220


1. change filters
2. upload pm
3. unlock




expertsgsm

[puneet1484]

[B]3390 to 3310

a complete guide for 3390 to 3310


http://rapidshare.com/files/5351998/...nvert.rar.html



expertsgsm

[puneet1484]

6200 to 6610

1. flash phone with nhl-4u (6610) mcu + ppm
2. replace filters
3. write pm
4. unlock



expertsgsm

[puneet1484]

6800a to 6800



1. flash with 6800a to 6800
2. replace filters
3. make jumper near the antenna sw
4. write pm
5. unlock




expertsgsm

[puneet1484]

6061 to 6060


1. erase whole flash as 6060.
2. flash ur 6061 with 6060 flash pack "RH-73_dp_46_00_ams_sw_4_10".
3. replace 2 filters
4. write pm
5. unlock



expertsgsm

[puneet1484]

8390 to 8310




Jumper resistor is a resistor (not actually a resistor)
with 0 ohm value, usually colored green with 0 markings.

Wire can also be use instead, but must not be very thin
and should be as short as possible. Thin and long wire
will introduce high inductive reactance and will result
to weak received signal.


2. T500 can be taken from 3310 unit. It is located just
above HAGAR, refer to your service manual to easily
locate it. Also take note to its pin orientation during
installation.

Bypassing Z551 with wires is not recommended,
this will weaken the receiver sensitivity due to incorrect
signal phase relationship.


3. Give special attention when installing VCO, improper
positioning will result to no network activity



expertsgsm

[puneet1484]

NgageQda to NgageQd




1. Erase flash with special erase
2. flash mcu & ppm to ngageqd
3. replace filters
4. write pm
5. unlock



expertsgsm

[puneet1484]

6101b to 6101

No software modification is required coz 6101b is already a GSM tri-band (850_900/1800/1900) but you can also flash it with RM-76 Data Package.

since phone is tuned to 850 MHz otherwise no network or weak network..

write pm (6101)



expertsgsm

[puneet1484]

over 90 views yet....post some results or comments

[kennyluuuuu]

What tool box for flash 6030b bro? After change the filter I used N-box and JAF to flash the phone to 6030 RM-74 but the same problem phone dead. When i reflash to RM-225 it can power now. Any solution for me please. Can i unlock it with JAF box or N-BOX

Many thanks

[..::Mr_Fone::..]

Good Job Keep It Up
..::mr Fone::..

[puneet1484]

What tool box for flash 6030b bro? After change the filter I used N-box and JAF to flash the phone to 6030 RM-74 but the same problem phone dead. When i reflash to RM-225 it can power now. Any solution for me please. Can i unlock it with JAF box or N-BOX

Many thanks

i have checked it with ufs.....erase full flash first........post result

[naveed805]

add more plz all pics r very use full

br
naveed

[..::Sunil::..]

Ohh nice copy and paste thanks.

B.r.
Sunil.

[john_john]

very nice colection i hope more update bro......keep it up