hello sir recently I have bought a uct box. it came with gpg cables. among them there is a cable without any connector. it have 24 pinouts but I don't know which pinouts should be used for rx and tx. plz help
hello sir recently I have bought a uct box. it came with gpg cables. among them there is a cable without any connector. it have 24 pinouts but I don't know which pinouts should be used for rx and tx. plz help
bro U can Use
Red As RX
Orange As TX
Black As Gnd
but bro this cable has not any wires it has only 24 prints
I want to know whichg prints should be connected to the rx, tx, and ground of a mobile from this cable
PLZ HELP I AM CONFUSED ABOUT THIS.
Last edited by Mubarak Alam; 21-07-2011 at 10:08 AM.
Use Any From Pin 1 to 24 as Rx, Tx & GND
Software will Automatically Detects Them...
Check This :
Attachment 27361
ok, thanks a lot. keep up helping
brother i have gpg open cables.when i attach open cables on mobiles pinouts and grnd positive and negative but set on not showing local mode.i try many times on different mobiles but problem is same plz help me i can do
bro, connect like this may be your problem solved
100_1666.rar100_1666.rar100_1666.rar
Last edited by Mubarak Alam; 08-01-2012 at 06:52 PM. Reason: for attach the image
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks